Category
- Academic DIY Kits
- Academic Hobby Projects
- Academic Major Projects
- Academic Minor Projects
- Aeromodelling & Drone
- Development Boards
- Electronics- Active Parts
- Electronics- Passive Parts
- Electronics- Sensors
- Electronics– Accessories
- Electronics–Modules
- Mechanical Parts
- Motor, Actuator & Pump
- Robot Accessories
- Supply- Battery, Adopters
- Tools & Equipment
Top rated products
-
10mm Black Toy Motor Pulley
₹6.00₹4.00 -
Desoldering Pump Aluminum (Round Tip)
₹110.00₹95.00 -
9 inch Rack With 25 Teeth Pinion
₹165.00₹150.00 -
BC547 NPN Transistor
₹6.00₹4.00 -
Pulse/Heart Rate Sensor Module
₹280.00₹240.00
This IC LM358 is 8-pin IC. These devices consist of two independent, high-gain frequency-compensated operational amplifiers designed to operate from a single supply or split supply over a wide range of voltages. Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground. Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V (26 V for LM2904). Open-Loop Differential Voltage Gain is 100 dB.
Technical specifications:
- Integrated with two Op-Amps in a single package
- Wide power supply Range
- Singe supply – 3V to 32V
- Dual supply – ±1.5V to ±16V
- Low Supply current – 700uA
- Single supply for two op-amps enables reliable operation
- Short circuit protected outputs
- Operating ambient temperature – 0˚C to 70˚C
- Soldering pin temperature – 260 ˚C (for 10 seconds – prescribed)
- Available packages: TO-99, CDIP, DSBGA, SOIC, PDIP, DSBGA
Package Includes:
- 1 Piece –LM358 IC Low Power Dual Operational Amplifier Op Amp IC
Weight | 2 g |
---|
Related products
-
L293D Motor Driver IC Dual H-Bridge
₹60.00₹55.00Add to cartL293D is a dual H-bridge motor driver integrated circuit (IC). Motor drivers act as current amplifiers since they take a low-current control signal and provide a higher-current signal. This higher current signal is used to drive the motors. L293D contains two inbuilt H-bridge driver circuits. In its common mode of operation, two DC motors can be …
-
HT12 Encoder & Decoder IC (1 Pair)
₹90.00₹70.00Add to cartThe HT12E Encoder ICs are series of CMOS LSIs for Remote Control system applications. They are capable of Encoding 12 bit of information which consists of 8 address bits and 4 data bits. Each address and data input is externally programmable or fed in using switches. The HT12D Decoder ICs are series of CMOS LSIs …
-
ULN2003 IC – Darligton Transistor Array
₹32.00₹25.00Add to cartThe ULN2003 is a Darlington array IC it can be used to drive Stepper and DC Motors, Relays, Solenoids, and other external circuits operating at high voltages and currents from simple CMOS logic signals from microcontrollers. It has 8 driving channels, each channel can withstand peak currents of 600mA. Suppression diodes are included for back …
-
L298N Motor Driver Dual H-Bridge IC
₹190.00₹150.00Add to cartL298N is a high power version of L293D motor driver IC. It is a high voltage, high current, dual full-bridge driver designed to accept standard TTL logic levels (Control Logic) and drive inductive loads such as relays, solenoids, DC and Stepper motors. Two enable inputs are provided to Enable or disable the device independently of the input signals. The emitters …
Reviews
There are no reviews yet.