Category
- Academic DIY Kits
- Academic Hobby Projects
- Academic Major Projects
- Academic Minor Projects
- Aeromodelling & Drone
- Development Boards
- Electronics- Active Parts
- Electronics- Passive Parts
- Electronics- Sensors
- Electronics– Accessories
- Electronics–Modules
- Mechanical Parts
- Motor, Actuator & Pump
- Robot Accessories
- Supply- Battery, Adopters
- Tools & Equipment
Top rated products
-
ULN2003 Stepper Motor Driver Module
₹150.00₹90.00 -
ESP-01 ESP8266 Serial WIFI Transceiver Module
₹180.00₹160.00 -
Square Toy Motor Metal Clamp
₹20.00₹12.00 -
4x3 Membrane Switch Keypad
₹105.00₹80.00 -
360 Degree Universal Drilling Machine ₹4,500.00
The MQ-6 module is used in gas leakage detecting equipment in family and industry, This module has high sensitivity to LPG, iso-butane, propane and LNG. It can also be used to detect the presence of alcohol, cooking fumes, and cigarette smoke. The module gives out the concentration of the gases as a analog voltage equivalent to the concentration of the gases. The module also has an onboard comparator for comparing against an adjustable preset value and giving out a digital high or low. It can be easily interfaced with your Arduino or Raspberry Pi.
This is a simple-to-use MQ-6 Liquefied Petroleum, iso-butane, propane gas Sensor module, suitable for sensing LPG (composed of mostly propane and butane) concentrations in the air. The MQ-6 can detect gas concentrations anywhere from 200 to 10000ppm.This sensor has a high sensitivity and fast response time. The sensor’s output is an analog resistance. The drive circuit is very simple; all you need to do is power the heater coil with 5V, add a load resistance, and connect the output to an ADC.
Sensitive material of MQ-6 gas sensor is SnO2, which with lower conductivity in clean air. When the target combustible gas exist, The sensor’s conductivity is more higher along with the gas concentration rising. Please use simple electro circuit, Convert change of conductivity to correspond output signal of gas concentration.MQ-6 gas sensor has high sensitivity to Propane, Butane and LPG, also response to Natural gas. The sensor could be used to detect different combustible gas, especially Methane, it is with low cost and suitable for different application.
Technical Specifications:
- Voltage: 5V
- Detecting concentration :200-10000 ppm LPG
- High Sensitivity Gases: LPG, iso-butane, propane
- Small sensitivity Gases: alcohol, smoke
- Analog and Digital Output
- Long life and low cost
- Simple drive circuit
- Digital Out is High or Low based on a adjustable preset threshold.
- Good sensitivity to Combustible gas in wide range
- High sensitivity to Propane, Butane, LPG and also response to Natural gas
Package Includes:
- Piece- MQ 6 – Gas Leakage Sensor Module
Weight | 20 g |
---|
Related products
-
Tsop Proximity Sensor Module
₹180.00₹150.00Add to cartThe TSOP 1738 is a member of IR remote control receiver series. This IR sensor module consists of a PIN diode and a preamplifier which are embedded into a single package. The output of TSOP is active low and it gives +5V in off state. When IR waves, from a source, with a center frequency of 38 kHz incident on it, …
-
1 Channel 5Volt Relay Module
₹95.00₹80.00Add to cartThis is a 5V, Single Channel Relay interface board; it’s useful to control various appliances, and other equipment’s with large current. It can be controlled directly by any Micro-controller (Raspberry Pi, Arduino, 8051, AVR, PIC, ARM, DSP, MSP430). Relay board module is used for controlling higher current loads from your microcontroller development board, PC parallel port or …
-
RF 433 MHz Transmitter & Receiver Module (Only RF)
₹180.00₹150.00Add to cartThis hybrid RF Module (Transceiver) module provides a complete RF transmitter and receiver module solution which can be used to transmit data at up to 3 KHz from any standard CMOS/TTL source. The transmitter module is very simple to operate and offers low current consumption (typical. 11mA). Data can be supplied directly from a microprocessor or …
-
FT232RL / Uart 6 Pin TDI USB To TTL Serial Converter Adapter Module
₹210.00₹140.00Add to cartEasily convert USB to TTL serial using this FT232 module. Plug one end into your USB port and on the other you’ll have TTL Serial on the 6 pins. This module converts a USB port into a serial port, with TTL voltage levels compatible with most microcontroller cards such as Arduino / Pic / Raspberry …
FT232RL / Uart 6 Pin TDI USB To TTL Serial Converter Adapter ModuleRead More
Reviews
There are no reviews yet.