Category
- Academic DIY Kits
- Academic Hobby Projects
- Academic Major Projects
- Academic Minor Projects
- Aeromodelling & Drone
- Development Boards
- Electronics- Active Parts
- Electronics- Passive Parts
- Electronics- Sensors
- Electronics– Accessories
- Electronics–Modules
- Mechanical Parts
- Motor, Actuator & Pump
- Robot Accessories
- Supply- Battery, Adopters
- Tools & Equipment
Top rated products
-
Two Leg Robot (Bi Pad)
₹850.00₹725.00 -
1000 RPM- Johnson Geared Motor Side Shaft
₹475.00₹425.00 -
W1209 Digital Temperature Controller Thermostat Module
₹205.00₹180.00 -
Alligator Crocodile Small Clip Pair Red & Black
₹12.00₹10.00 -
ADXL345 - Triple Axis Linear Accelerometer
₹125.00₹120.00
The NE555 has a trigger level of approximately one-third of the supply voltage and a threshold level equal approximately to two-thirds of the supply voltage. These levels can be altered by use of the control voltage terminal (CONT). The 555 can be used in countless applications and has three recognised operating modes. In mono stable mode the 555 functions as a one-shot or pulse stretcher. Applications include timers, missing pulse detection and bouncefree switches. In a-stable mode the 555 can operate as an oscillator. Applications include LED and lamp flashers, pulse generation, logic clocks, tone generation, security alarms and Pulse Width Modulation (PWM). In bi-stable mode the 555 can operate as a flip-flop or changeover. Applications include bouncefree latched switches.
This is a common 555 timer/oscillator. A classic for all circuits projects where you need to blink an LED, generate tone, and thousands of other great beginning projects.
Technical Specifications:
- 4.5V to 16V supply
- 8-pin DIP package
- Timing from microseconds to hours
- Astable or monostable operation
- Adjustable duty cycle
- TTL compatible output
- Sink or source up to 200mA
Package Includes:
- 1 Piece – LM 7812 Positive Voltage Regulator IC- 12 Volt/1 Amp
Weight | 2 g |
---|
Related products
-
ULN2003 IC – Darligton Transistor Array
₹32.00₹25.00Add to cartThe ULN2003 is a Darlington array IC it can be used to drive Stepper and DC Motors, Relays, Solenoids, and other external circuits operating at high voltages and currents from simple CMOS logic signals from microcontrollers. It has 8 driving channels, each channel can withstand peak currents of 600mA. Suppression diodes are included for back …
-
LM358 IC Low Power Dual Operational Amplifier Op Amp IC
₹15.00₹9.00Add to cartThis IC LM358 is 8-pin IC. These devices consist of two independent, high-gain frequency-compensated operational amplifiers designed to operate from a single supply or split supply over a wide range of voltages. Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground. Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V (26 …
LM358 IC Low Power Dual Operational Amplifier Op Amp ICRead More
-
L293D Motor Driver IC Dual H-Bridge
₹60.00₹55.00Add to cartL293D is a dual H-bridge motor driver integrated circuit (IC). Motor drivers act as current amplifiers since they take a low-current control signal and provide a higher-current signal. This higher current signal is used to drive the motors. L293D contains two inbuilt H-bridge driver circuits. In its common mode of operation, two DC motors can be …
-
HT12 Encoder & Decoder IC (1 Pair)
₹90.00₹70.00Add to cartThe HT12E Encoder ICs are series of CMOS LSIs for Remote Control system applications. They are capable of Encoding 12 bit of information which consists of 8 address bits and 4 data bits. Each address and data input is externally programmable or fed in using switches. The HT12D Decoder ICs are series of CMOS LSIs …
Reviews
There are no reviews yet.