- Academic DIY Kits
- Academic Hobby Projects
- Academic Major Projects
- Academic Minor Projects
- Aeromodelling & Drone
- Development Boards
- Electronics- Active Parts
- Electronics- Passive Parts
- Electronics- Sensors
- Electronics– Accessories
- Mechanical Parts
- Motor, Actuator & Pump
- Robot Accessories
- Supply- Battery, Adopters
- Tools & Equipment
DIGITAL MULTI SERVO TESTER ESC RC CONSISTENCY CCPM MASTER SPEED CONTROL can connect 1-3 servos simultaneously and test such as 1-3 servos consistency and so on. You can also connect 1-3 ESC to test and compare their reaction time respectively. It can connect 3 servos of the CCPM helicopters and select servos. It can also connect the servo of airplanes to install the steering-box and adjust planes by using such as the neutral mode and so on.
Digital multi servo tester esc RC consistency ccpm master speed control can be used as a signal generator for electric speed controller (ESC), and then you can test your motor system without using a transmitter and receiver.
There are 3 modes to check servos or ESC:
- Manual mode: turn the knob with different speeds, check the reaction time.
- Neutral mode: make the servo go back to the neutral point.
- Automatic / window wiper/ mode: make the servo swing like a window wipers in the biggest angle.
- Digital Multi Servo Tester Esc RC Consistency CCPM Master Speed Control
- 1 Piece- Digital Multi Servo Tester ESC CCPM Consistency Master Speed Control
L9110S H Bridge Stepper Motor Dual DC Driver
₹140.00Add to cart
The HG7881 (L9110) is a compact motor driver board that supports a voltage range from 2.5-12V at 800mA of continuous current. These chips have built-in output clamp diodes to protect your sensitive microcontroller electronics. They are suitable for small robot projects. Each L9110 chip is able to drive a single DC motor using two digital …
A4988 Stepper Motor Driver Module with Aluminum Heat Sink
₹240.00Add to cart
A4988 is a complete micro-stepping motor driver with built-in translator for easy operation. This product is available in full, half, 1/4, 1/8 and 1/16 step modes operate bipolar stepper motors, output drive capacity of up to 35 V and ± 2 A. A4988 includes a fixed off-time current regulator, the regulator in slow or mixed …
Dual Motor Driver L293D Module With 7505
₹120.00Add to cart
Dual Motor Driver L293D Module With 7505-contains two inbuilt H-bridge driver circuits and direct IR module input . In its common mode of operation, two DC motors can be driven simultaneously, both in forward and reverse direction. The motor operations of two motors can be controlled by input logic at pins 2 & 7 and …
L298N Dual Motor Driver Module (Up to 3~4 Amp)
₹195.00Add to cart
Using L298N as the control chip, the module has such characteristics as strong driving ability, low calorific value, and strong anti-interference ability. This module can use built-in 78M05 for electric work via a driving power supply part. But to avoid the damage of the voltage stabilizing chip, please use an external 5V logic supply when …